Deluxe Stainless steel Projecting sheet spillways
|
 |
 |
Standard
back water inlet
1 1/4" BSP
female thread ready to take a hose tail or elbow. |
Standard
bottom water inlet
1
1/4" BSP female thread ready to take a hose tail
|
Spillway
installation choices
|
 |
 |
|
Typical
spillway installation.... When the wall is thick eg. Block or
brick etc In this case a back
water inlet choice should be chosen. |
Typical
spillway installation.... When the wall is thin eg. Blue board,
plywood, glass etc In this case the
bottom water inlet choice should be chosen. |
Pump installation
choices - In pond or outside pond
|
 |
 |
Typical
pump installation.... A submersible pump is positioned in the pond
with water pumped through the pond wall and up to the spillway.
Note: This is the best way to set up your pump from
the stand point of the pumps performance, as any pump noise (mostly
associated with less expensive pumps) is muffled, the pump is kept cooler
and therefore will have a longer life, in most cases a pre filter can be
attached to the pump. |
Optional pump installation ... A pump suitable for dry mounting
is positioned behind the pond and the water is then pumped up to the
spillway.
Note: This arrangement allows the pump to be hidden, however
the benefits mentioned in the in-pond option such as noise, cooling are
lost. |
 |
Filter system?
If the pond is large enough you may wish to consider some for of filtration.
Shown here is an external pressure filter, however in pond filters are also
available.
|
Showing a side and front view of the Sheer
descent (Projecting sheet) in action with a thick wall, however, wall
thickness down to a few mm is fine. |
Neat and tidy
A method of getting both the electrical cable (with plug intact), and the
hose out of the pond.
At the same time the pump can be removed for servicing without the plug
being cut off or having the cord and hose over the ponds edge.
|
See our
plumbing section
for more details and choices of Hansen through wall fittings |
Hansen through wall fitting .... for passing hose through the
pond wall, 5 thread sizes from 1/2" to 2" BSP and a wide choice of
lengths and matching barb hose fittings look at our
plumbing section
or call for more details. Each fitting Rubber washers for water tight seals.
|
